Linux Software Raid: Difference between revisions
From DWIKI
m (→HOWTO) |
m (→HOWTO) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 12: | Line 12: | ||
*[https://unix.stackexchange.com/questions/332061/remove-drive-from-soft-raid Remove a disk from soft raid] | *[https://unix.stackexchange.com/questions/332061/remove-drive-from-soft-raid Remove a disk from soft raid] | ||
*[https://www.thomas-krenn.com/en/wiki/Mdadm_recovery_and_resync Mdadm recovery and resync] | |||
=HOWTO= | =HOWTO= | ||
| Line 22: | Line 23: | ||
==Re-add disk to array== | ==Re-add disk to array== | ||
mdadm /dev/md0 - | mdadm /dev/md0 --re-add /dev/sdc1 | ||
==List devices== | |||
Just | |||
cat /proc/mdstat | |||
=What the howto and man mdadm don't tell= | =What the howto and man mdadm don't tell= | ||
Latest revision as of 14:41, 15 April 2024
Links
- A guide to mdadm
- mdstat
- How to use MDADM to manage software RAID disc arrays
- How To Manage RAID Arrays with mdadm
- RAID
- Software RAID Howto
- http://gentoo-wiki.com/HOWTO_Gentoo_Install_on_Software_RAID
- COMMON RAID DISK DATA FORMAT (DDF)
- Switching to mirroring
- http://www.sanitarium.net/golug/Linux_Software_RAID.html
HOWTO
Scan devices
mdadm --examine --scan --verbose /dev/sda2 /dev/sdb2 /dev/sdc2
Stop array
mdadm --stop /dev/md0
Re-add disk to array
mdadm /dev/md0 --re-add /dev/sdc1
List devices
Just
cat /proc/mdstat
What the howto and man mdadm don't tell
Checking the raid units
From man md:
echo check > /sys/block/md0/md/sync_action
check /proc/mdstat for status, and then set back to idle:
echo idle > /sys/block/md0/md/sync_action
Looking at your raid units
cat /proc/mdstat mdadm --detail /dev/md0
(also shows what's going on when checking/resynching)
Hotswapping (scsi) disks
eject -s /dev/sda
